
Wholesale* Sculptra 5 ml vials
Sculptra Aesthetic (injectable poly-L-lactic acid) is indicated for use in people with healthy immune systems as a single regimen for the correction of shallow to deep nasolabial fold contour deficiencies and other facial wrinkles in which deep dermal grid pattern (cross-hatch) injection technique is appropriate.
Sculptra is an injectable cosmetic filler that can be used to restore facial volume lost due to aging or illness.
It contains poly-L-lactic acid (PLLA), a biocompatible synthetic substance that stimulates collagen production.
It can be used to treat deep lines, creases, and folds to give a more youthful appearance.
It’s also used to treat facial fat loss (lipoatrophy)
Sculptra is used to diminish facial wrinkles and folds and has been clinically approved to treat smile lines and other wrinkles around the nose and mouth as well as chin wrinkles.
Sculptra has many off-label uses, including: nonsurgical butt lift or buttock augmentation, correction of cellulite, correction of chest, elbow, and knee wrinkles
How does Sculptra work?
Sculptra is injected into the skin to diminish facial wrinkles. It contains PLLA, which acts as a collagen stimulator, helping to gradually restore fullness to facial wrinkles and folds. This results in a softer and more youthful appearance.
You may notice immediate results, but it can take a few months to see the full results of your treatment.
Your Sculptra specialist will work with you to determine the number of treatment sessions needed to achieve the best result. The average regimen consists of three injections spread out over three or four months.
Convenience:
The procedure is performed in-office by a trained provider.
No pretesting is required for Sculptra treatments.
You can return to your normal activities immediately after treatment.
There is no special preparation required.
Sculptra Reconstitution Protocol
Add 5 mL of Sterile Water For Injection (SWFI) & shake vigorously for about 1 minute, until homogeneous suspension is achieved.
Add additional 3 mL of Sterile Water For Injection (SWFI) and shake again until suspension is homogeneous.
Add an optional 1 mL of 2% lidocaine to the solution immediately before injecting to aid patient comfort.